PRIOR TO USING THIS PRODUCT, PLEASE READ THESE INSTRUCTIONS FULLY AND CAREFULLY.
​
Before starting
Please keep in mind that these instructions only contain general information and recommendations about how to use OLDWOOD DOT. If in doubt, you should get independent advice on the usage, application, and installation of this product from competent and authorized professionals (locally).
​
Consult local building codes to ensure that this product is used in accordance with the standards for good construction.
1.
OLDWOOD DOT should only be used as a decorative interior cladding.
2.
OLDWOOD DOT is supplied with a finish suited to private and commercial use.
3.
To acclimatise OLDWOOD DOT material prior to installation, it should be removed from its packaging and stored for 48 hours where it will be handled and at handling temperature. Full adhesion will be achieved after 72 hours.
4.
Avoid any sort of surface contamination when handling, as it may be difficult to remove.
5.
When handling, use appropriate, clean tools. A spirit level, a fine-toothed saw, a square, a folding rule, and a pencil are all recommended.
6.
Keep a clean work area when handling OLDWOOD DOT. If the adhesive strip is applied incorrectly, it must be carefully removed with a damp cloth and clean water.
7.
OLDWOOD DOT products are temperature resistant to at least 5°C and up to 60°C.
8.
Install the product at temperatures ranging from 15 °C to 35 °C.